Primary E-Mail
scott@evdeals.com
Alternate E-mail
ghastly1@yahoo.com
snit33a@verizon.net
smacgregor@aasp.net
Call 508-695-3717
Fax 508-643-0233
ELECTRIC
POLITICS
EVdeals Policies
Battery Tests
Dynamometer Tests
FAQs
Tech
Tips
Performance
Testing
Pictures of Custom Projects
Plans & Projects
Instructions
Yard Sale
Bob the Blob in Safety
First
(brief you-tube video)
Join
the Yahoo electric scooter e-mail group FREE!
Click HERE
© 1999-2010 EVdeals.com
No part of this site may be reproduced or
transmitted in any form or by any means, electronic or mechanical,
including photo- copying, recording, or by any information storage and
retrieval system
without permission in writing from the publisher.
By appointment only!
Scott MacGregor
Plainville, MA 02762
Phone: (508) 695-3717
Fax: (508) 643-0233
Remove the existing caliper brake system. Save the thick curved washers from this assembly for later use. (they are installed against the curved portion of the steering fork in the front and rear of the caliper mounting bolt)
Using the bolt and nut in your V-brake kit, and the two thick curved washers from above, install the chrome adapter plate as shown in the picture. Do not tighten the bolt until the hose clamps are installed. Be sure to install one of the thick curved washers between the adapter plate and the fork. This provides a clearance that is necessary for the assembly to tighten down properly.
Install the hose clamps through the slots cut in the adapter plate, and tighten. Tighten the clamps and upper bolt (through the fork) alternately until the adapter plate is completely secure. The adapter plate should be securely tightened for safe brake operation!
Using the instructions supplied with the Shimano V-Brake kit, install the rest of the brake system. In many cases, the existing brake cable will be too short to work properly with the new V-Brake system. If necessary, use the brake cable provided (pre-cut to proper length) to complete the installation.